PERANCANGAAN MESIN PENGERING MINYAK KAPASITAS 10 KG

Sir Anderson

Abstract


Repeated heating of paml oil has a greater effect to produce high levels of trans fat. The excess consumsion of food contained trans fat is couse of diabetes and coronary heart diseas. The oil spinner machine of 10 kg capacity are proposed to overide this problem because it is able to throw the oil particles out from the fried food caused by centrifugal force. The drying area is a 50 cm long tube having diameter of 40 cm which is driven by an electric motor single-phase 1 Hp 1400 rpm. In order to increase the speed of the drying tube into 2800 rpm, a 6 inch diameter pulley attached to the motor shaft while a 3 inch is mounted on a 10 cm diameter drying tube shaft. The two pulleys are connected by means of an open belt drive with a length of 60 inch and 187,480 the contact angle.

Keywords


oil spinner design, 10 Kg capacity, drying tube, pulley and belt

Full Text:

PDF

References


Ilmi, Ibnu Malkan Bakhrul, Ali Khomsan, and Sri Anna Marliyati. "Kualitas minyak goreng dan produk gorengan selama penggorengan di rumah tangga Indonesia." Jurnal Aplikasi Teknologi Pangan 4.2 (2015).

Muchlis, R.D., Patrick Andreas, Bakti Jos, dan Siswo Sunardiono. 2013. Modifikasi Ubi Kayu dengan Proses Fermentasi Menggunakan Starter lactobacillus casei untuk Produk Pangan. Semarang. Jurnal Teknologi Kimia dan Industri, Vol. 2, No. 4 :137-145.

Nur, Rusdi & Sayuti, Arsyad. (2017). Perancangan Mesin-Mesin Industri. Yogyakarta: Budi Utama

Pramono. P. G (2012). Perancangan Mesin Penyuir Daging Untuk Bahan Baku Abon. Yogyakarta (ID): Universitas Negeri Yogyakarta.

Shigley. J. E.& Mitchell. L. D. 1984. Perencanaan Teknik Mesin, Jakarta, penerbit Erlangga.

Sularso & Suga, Kiyokatsu. (2002). Dasar Perencanaan dan Pemilihan Elemen Mesin. Jakarta: Pradya Paramita

Susilawati, Siti Nurdjanah, dan Sefanadia Putri. 2008. Karakteristik Sifat Fisik Dan Kimia Ubi Kayu (ManihotEsculenta) Berdasarkan Lokasi Penanaman Dan Umur Panen Berbeda. Lampung. Jurnal Teknologi Industry Dan Hasil Pertanian Vol. 12, No. 2.




DOI: http://dx.doi.org/10.30630/jipr.17.2.225

Refbacks

  • There are currently no refbacks.


Published by Pusat Penelitian dan Pengabdian Kepada Masyarakat Politeknik Negeri Padang, Jurnal Ilmiah Poli Rekayasa| p-ISSN: 1858-3709 | e-ISSN : 2685-3922| DOI: 10.30630/jipr

Creative Commons License